Juice Goose IP Series Power Conditioners

This driver controls the Juice Goose IP series power conditioners. It was written with the IP-1520 and IP-50 as a test unit. There is no serial control of the unit, it is IP controlled only at this time.

Revision History
1.0 The initial release of the driver.

1.1 Updated to work with IP-50.

Driver Configuration

TCP Address:

• Enter the IP Address of the unit to be controlled.

TCP Port:

• Leave this at the default unless instructed otherwise.

User Name:

• Enter username used to access web interface.

Password:

• Enter password used to access web interface.

POD Count:

• Enter the number of PODs to be used.

POD Names:

• Name each POD as desired. The new name will replace the old one everywhere it is used as a variable.

*All configuration of the power conditioner needs to be done via the web interface.

Control

Only the PODs are controllable in this system. The PODs can be controlled individually or through a “Sequence” command. The “Sequence” command allows the PODs to be turned on or off at an interval specified in seconds. The interval is determined when the command is assigned or in the properties of the button that the command is assigned to. All configuration of the device needs to be done via the web interface.

Variables

The following variables are available:

• POD names.

• POD power status.

• POD current status in amps.

• Manual Override status.

Events

Events are triggered:

• When a POD goes on or off (separate events).